Zilog Z51F0811 Manual de usuario descargar pdf (Pagina 24)

UM024002-0512 The Z8051 On-Chip Debugger

Z8051 On-Chip Debugger and In-System Programmer

User Manual

Go From

The Go From menu selection starts emulation from a user-specified address, and is used to

debug each software module. The user is prompted to enter an emulation start address, as

follows:

•

Using LINEAR ADDRESS Mode, enter a 20-bit address directly.

•

Using BANKED ADDRESS Mode, enter 4 bits of bank and 16 bits of address. Each

bank size is smaller than or equal to 64 KB.

The Go From function is disabled (greyed out) in the Emulation menu during emulation.

The Go function begins emulation from the current address, which can be characterized

as:

•

The last known (stopped) address that was held in the Program Counter from a previ-

ous emulation session

•

The point at which a break occurs, such that:

– If a break occurs before the breakpoint, the current address is the PC breakpoint

address

– If a break occurs after the breakpoint, the current address is the next execution

address of the PC breakpoint address

•

If the target MCU was reset, the reset address is 0000h.

The Go function is disabled (greyed out) in the Emulation menu during emulation.

Step

The Step function is used to debug each instruction flow and process one step at a time;

the target MCU program flow will execute only one instruction at a time, then halt.

If the MCU receives a CALL instruction, it executes a Step run into the subroutine. If

MCU is in STOP Mode, the Step run is ignored. The Step function is disabled (greyed out)

in the Emulation menu during emulation.

Step Over

The Step Over function is used to check main program flow when each subroutine had

been tested already. This function is similar to the Step function, with the exception of its

subroutine call. If the MCU receives a CALL instruction, the debugger assumes the CALL

and its subroutine to be one instruction, even if the subroutines are nested.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 95 96

Sin comentarios

Zilog Z51F0811 Manual de usuario Pagina 24