Zilog ZUSBOPTS Manual de usuario descargar pdf (Pagina 118)

Menu Bar UM017105-0511

Zilog Developer Studio II – ZNEO™

User Manual

12. Enter the appropriate offset values in the File Offset field to offset the base address of

the hex file. The hex file address is shifted by the offset defined in the

Start Address

area; however, you must allow for the shift in any defined jump table index. This off-

set value also shifts the erase range for the Flash.

13. Select the

Erase Before Flashing checkbox to erase all Flash memory before writing

the hex file to Flash memory.

Be careful when selecting pages from which to delete Flash memory. Clicking

ERASE deletes only the pages that are selected.

14. If appropriate, select the

Close Dialog When Complete checkbox to close the dialog

box after writing the hex file to Flash memory.

15. To use the serialization feature, observe the following procedure.

a. Select the

Include Serial in Programming checkbox. This option programs the

serial number after the selected hex file has been written to Flash.

b. Select the

Enable checkbox.

c. Enter the start value for the serial number in the

Serial Value field and select the

Dec button for a decimal serial number or the Hex button for a hexadecimal serial

number.

d. Enter the location in which you want the serial number to be located in the

Address Hex field.

e. Select the number of bytes that you want the serial number to occupy in the

Bytes

drop-down menu.

f. Enter the decimal interval that you want the serial number incremented by in the

Increment Dec (+/–) field. If you want the serial number to be decremented, enter

a negative number. After the current serial number is programmed, the serial num-

ber is then incremented or decremented by the amount in the Increment Dec (+/–)

field.

g. Select the

Erase Before Flashing checkbox. This option erases the Flash before

writing the serial number.

h. Click

Burn Serial to write the serial number to the current device or click Pro-

gram

or Program and Verify to program the Flash memory with the specified

hex file and write the serial number.

16. If you want to check a serial number that has already been programmed at an address,

perform the following brief procedure.

a. Select the

Enable checkbox.

b. Enter the address that you want to read in the

Address Hex field.

c. Select the number of bytes to read from

# Bytes drop-down menu.

Caution:

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 519 520

Comentarios a estos manuales

Sin comentarios

Zilog ZUSBOPTS Manual de usuario Pagina 118

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Zilog ZUSBOPTS