Zilog Z16C35 Manual de usuario descargar pdf (Pagina 274)

Application Note

Boost Your System Performance Using The Zilog ESCC

™

13-7

AUTOMATIC /RTS DEASSERTION

Several SDLC enhancements are provided in the ESCC.

The ESCC allows automatic /RTS deassertion at End Of

Frame (EOF). The automatic /RTS deassertion is enabled

by setting WR7' D2. If ESCC is programmed for SDLC

mode and the Flag-On-Underrun bit (WR10 D2) is reset,

with the RTS bit (WR5 D1) reset, /RTS is deasserted

automatically at the last bit of the closing flag. It is triggered

by the rising edge of the Transmit Clock (TxC - Figures 6

and 7).

/RTS is normally used in SDLC for switching the direction

of line drivers. Automatic /RTS deassertion allows optimal

line switching without any software intervention. The

typical procedures are as follows:

1. Enable Automatic /RTS Deassertion

2. Before frame transmission, set RTS bit

3. Enable frame transmission

4. Reset RTS bit

5. RTS pin deassertion is delayed until the last rising TxC

edge closing flag.

Figure 6. /RTS Deassertion Timing

TX Underrun/EOM

/RTS Pin

Data CRC1 CRC2 Flag

RTS Bit

(WR5, D1)

Data Being Sent

Figure 7. /RTS Deassertion Sequence

TX Closing

Flag

TXC

TXD

/RTS

Mark

Automatic RTS Pin Deactivation

Page 268 of 316

UM011002-0808

1 2 ... 269 270 271 272 273 274 275 276 277 278 279 ... 321 322

Sin comentarios

Zilog Z16C35 Manual de usuario Pagina 274